Engine was out and I went to install the exhaust (its a U shaped piece that has to be in before the engine) of course I got concerned bout how many lines were supposed to run from the outdrive and into the boat.
As it turns out, it should be 2 hoses (one from trim up and one trim down ... IE an in and out hose for the hydraulic fluid). These hoses need to be in place and secure before installing the exhaust on these older boats because otherwise you can't access that area again.
I ended up buying a Clymer manual for that model year range (mid 60s - 80s) which has provided a fair bit of detail that really helps the re-assembly process. [How many hydraulic lines wasn't included, I had to scour the internet to figure that out.]
I'm also finding manuals to be lacking in terms of bolt sizes and lengths. That has taken some research and trial and error to resolve. Best advice I can give is label everything in a zip lock bag and keep it all together!
The project boat in question...
No comments:
Post a Comment